Watercooler Notebooks

Is your laptop often excessive heat? How to make your laptop become more of a cold right now you use? Here is a guide to create a radiator on a laptop you may be able to make reference to your laptop.

Disclaimer

Loud warning: If you sabotage something in this experiment it was your own fault, because in this experiment, as you know is basically the electronic mix with water as you know they feud with each other.
For those of you who will continue to step in a more then please continue to step 2, if you are not yet convinced then consider carefully to apply in your laptop.

Prepare laptop

Prepare a laptop, look first if you do not have it (pinjem neighbor, father, etc.). In this experiment using a compaq presario 700 laptop that overheated. Some of the methods can be done easily, it is easier if you have a larger fund to buy better equipment.

Preparation

• Pipe: Here, use 3 / 16 ID vinyl pipe
• Pipe again: Here, use 5 / 16 ID
• Pump: This is the pump power supply with it.
• Radiator: Here, use the add-on transmission cooler from the car
• Fan: The ... Here, using two (2) fan with a heat control
• Reservoir
• Power supply: 13.5 v Here the PSU to 12V PSU fan and pump funtuk.

Loading Laptops

Read the author's guide for how to do, or just loading what you can poke

Prepare the cooling block & Modif

Most laptops have integrated cooler cpu block / heat sink. Unloading the part and look how the water can go to the part. Compaq has a copper pipe at the top, cut the part and the lower cut. Then in hilangkanbagian. Then modify the part to look like in the picture.

Play Audio

Find a way how to play the pipe exit. Usually get in the cut, find a safe way to avoid a cut.

Place the tool on the back of the screen

Open up your monitor screen scree (carefully lcd is very dangerous) and then drill some holes. enter zip mounting or cable tie for the trans cooler holes through it.

Place the Radiator and Fan

Then take the radiator using a cable tie or zip. Then place the gasket on the top of the radiator fan on each, this will help move air to and from the place you want. Then install the fan in the place where you want and make sure that does not move with the round clip or cable tie or anything so permanent.

Connect the other

Now the radiator has been installed and then attach the pipe and reservoir double stick tape or anything that strong, and then attach the cable-the cable.

pray

Fill with water (use distilled water). lihatlah apakah ada yang bocor. see if there is a leak. Fix leaks (if any) and reset the stack. Place the cooling system with no leakage for 24 hours before you turn on your system (powering up). Some of the reservoir continues to leak, if you feel the same ha, make sure not too much air pressure in it.

Source: http://www.instructables.com